HPE Community
Netservers
1846265 Members
5059 Online
110256 Solutions
New Discussion

Help LC2000 Problem

 
kokila
Occasional Contributor

‎06-02-2003 03:39 AM

‎06-02-2003 03:39 AM

Help LC2000 Problem

Can anybody advise me to load SCSI (Symbios) drivers to initialize disk drives in order to load in DOS mode.
The drivers taken from Navigator CD is not working properly.
0 Kudos
1 REPLY 1
Jeroen_Kleen
HPE Pro

‎06-03-2003 10:48 PM

‎06-03-2003 10:48 PM

Re: Help LC2000 Problem

Hi,

To see the drives in DOS you don't need the DOS driver if you have the controller set to being the 1st bootable one. Then it's using the int13 so you can connect to it without a DOS driver.

Just in case you still need the DOS driver I attached my working version.

Just let me know if this still not working or you would like to something completely different.

Best regards, jeroen
(I am an HPE employee)
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.