How to boot from CD ? - Netserver LP Pro

[a2z]

Hi!
I have a netserver LP pro, i used ECU to access into cmos of this, but I don't know how to set boot from CD.
I want to setup win2000 advance server on this.
What must I do to boot from CD and setup win2000 ?
Thanks

[adam tekieli]

You probably want to setup Netserver LD Pro??
If so here some issues:
First you need ECU Floppy to configure your Server
From Main Menu
go to
-> Configure computer
-> Run configuration utility
-> Press Enter
-> use Step 3: View or edit details
-> use
SCSI - Device Configuration for Embedded SCSI
Wide SCSI Channel Configuration
SCSI Channel Interface Wide Channel, Single-Ended SCSI

-> BIOS configuration Press to configure Device configuration Press to configure

-> Support for Bootable CD-ROM set it to enable

W2k is offical not supported on this Server. I will prefer to start installation using w2k floppys and stoped automatic HW recognisation

[John Birkett]

If it in fact an LD Pro and not an LP Pro, you will be able to setup and run win2000 Advanced Server. I have successfully done this. Here are the problems I have run into.
Configuration:
LDPro, Single 200
3 4.2gb drives, non-raid using internal scsi.

The only problem I have had is the on-board VGA configures as a Trident 9320/9440/9470 VL/ISA and then will not start causing VgaSave to load and then conflict. You will get VGA 16 color and 800x600. If I install a different video card in another PCI slot then the IRQ for the on-board scsi gets in the way. I have resolved myself to using 800x600 unless I can find a newer driver.

Other than the video, everything else works find.
Regards,
John

[a2z]

Hi!
I think my computer has some problems,
I already make bootable from CD, but it can't boot into cdrom.
if I boot it by win98's startup disk and I
select first option: "...with cd support..."
my computer will have 3 drivers:
c: my hd
d: ram disk
e: network driver ?, and I can't access on this
Please tell me, what can I do now ?
Thank for your helps