HP Netserver LP1000r

[Bergen110]

Hello,

I have a question about an HP Netserver LP1000r.

Does this server have an integrated RAID controller?

Or must be an PCI board attached on the system?

Kind regards,

Bergen110

[Renjiv]

Hi,

The LP1000R does not have an integrated RAID controller built into the system board. If you need it, you will have to install a separate SCSI RAID controller into the one available PCI slot.

The NetServer LP 1000r has an embedded dual-channel Ultra 3 Wide PCI SCSI controller. It has 2 Channels. Channel A is used for cabling to the hot swap hard disk cage. Channel B is connected to an external port for external SCSI devices.

For adding an additional Disk Array Controller (NetRAID), as per the documents available, HP recommends only using the NetRAID “1Si “ (D2140A) PCI board in Netserver lp 1000r

Part number: D2140-69004

Description: NetRaid-1Si one-channel disk array controller - PCI board with one internal 68-pin High Density and one external 68-pin Ultra High Density SCSI connector.

However, the above part is currently not available in production.

****You may also refer below HP document for HP Netserver LP 1000r  FAQ:

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/lpn11481/lpn11481.pdf

Helpful links:

http://support.citrix.com/servlet/KbServlet/download/609-102-8132/HP_lp1000r_XP_TSE.pdf

http://www.mpcdrivers.com/sylvia/Support/Server/LP1000r/LP1000r%20Service%20Manual.pdf

Hope the info will help you :)

Regards,

Renji