lost password bios

[marco_114]

we had a youth and technical expert, that it unfortunately is dead in an ugly road accident, the new sistemist, doesn't know now the password of the bios of our server Hp netserver LH3 and of our pc hp vectra.
We have removed the battery of the cmos but without any risult
a way of reset the bios exists???
Thanks a lot of

[Rajesh Kumar Agrawal]

Marco,
You need to put jumper on the motherboard,
For that you may pl. refer to your Server or PC motherboard documents...

I hope this helps,
Rajesh

[Rajesh Kumar Agrawal]

Marco,
See also... following link.. if the model no. is not matching then you can surf Internet to search on hp for clearing CMOS.

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=tis02226

Rajesh

[malvin drakley]

Hi Marco if you look at the technical manual page 80/81 you will see the picture where the switches are.

http://h20000.www2.hp.com/bizsupport/TechSupport/Resource.jsp?locale=en_US&prodTypeId=15351&prodSeriesId=50447

switch 5 is the switch you require

malvin

[amhakassa]

Hi Marco,

If you still did not get it work do this (This steps is specifically for the LH 3 Netserver I am not sure about the Vectra. May be you have to look at the technical reference)

1. Open the server and locate the configuration switch on the mainboard which will be found close to the CMOS Battery
2. Flip Switch# 6 from OFF to ON and power up the server
3. After u got the password clear message, power down server and flip switch# 6 back from ON to OFF
4. Power up the server

This should take care of it

I hope this will help

Regards
Amha Kassa