LPR - Cannot boot mirror drive

[Virgil Furlow]

I have an LPR with mirrored drives. The first drive had the HP utility partition installed on it but the second did not. I lost the first drive, Now the second will only boot from a floppy. I fixed the boot.ini but it did not help. I think the problem is that the second drive is missing the HP utility partition. If I boot without the floppy I just get a blinking cursor in the upper left hand corner.


Thanks,
Virgil Furlow

[Marco Hogeveen]

Have you made the partition active in Disk Administrator???
Also be sure that the boot.ini on the harddisk referrs to the correct SCSI-ID.
More information on software disk mirroring can be found on http://support.microsoft.com/default.aspx?scid=kb;EN-US;Q120227.

Hope this helps.

Marco.

[Virgil Furlow]

I have made sure the partition is active. If I make a non bootable partition active I get a missing operating system error. Once I put the bootable c: drive back to active I only get the black flashing cursor. I have tried NT repair on boot files with no luck also.

[Marino Meloni_1]

hi
I already get a problem like this one time, if I remember well ther is a Microsoft document which can solve a problem like this due to a hight defragmentation of the hdd in the boot zone, this may be your problem.
did you check the active partition with FDisk?
bye
marino

[Robert Demmer_1]

Hi,
just to make your problem clear to me, your mirror configuration is (was) software based? Or do you use netraid adapter?

robert