HPE Community
Netservers
1859334 Members
1981 Online
110398 Solutions
New Discussion

Re: netraid 1si and W2k

 
David Reuß
New Member

‎10-31-2002 07:36 AM

‎10-31-2002 07:36 AM

netraid 1si and W2k

Hallo !
I have allready installed a new netraid 1si raid-controller in my computer.I have flashed the newest bios and firmware. But my problem is I can't use the raid because my computer will hang up by read or write on the disks. It is not an hp-netserver its a normal pc with a asus k7m board and 2 ibm drvs18v for a level 0 raid. I insttalled the newest hp-driver and configure the arrey with the hp netraid assitant, can format it and all will be fine,but if I want to read or write the system hangs up.Also I tryed to intall a new W2k on the arrey an its hangs up while the installation. The disks are ok i had never problems with them and i have checked them with the dft-tool too.I hope someone is answering me, because I can't find anything at the support. Please excuse my bad english.
David
0 Kudos
1 REPLY 1
Joaquin Gil de Vergara
Respected Contributor

‎10-31-2002 08:53 AM

‎10-31-2002 08:53 AM

Re: netraid 1si and W2k

probably your bios not support this card

That is an unsupported config, NetRAID card is only certified in HP Netservers.....

I'm sorry
Teach is the best way to learn
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.