Netserver 5/133 LC

[Bart Lim]

I recently got hold on an old netserver 5/133 LC..It has a pentium 133 mhz and 32 mb RAM.
I updated the bios for this netserver, but now I only have 1 mb RAM and a 100 mhz processor acording to the bios. What could have gone wrong and how can i fix thix.

[Theo Hill_1]

What BIOS did you update too? Did you get it from the HP webpage? Here is the link: http://www.hp.com/cgi-bin/cposupport/swindex.pl?p=hpnetserve5436&l=en&c=BIOS

Have you tried booting to the ECU? Try and do a save and exit.
Also, try and clear the config on the system by booting setting switch 3 on the system board to the on position then booting, at the end of post, power down the system, flip the switch back, then boot to the ECU and save and exit.

[Bart Lim]

I did update to that bios, the latest LC Bios. I also tried booting to the ECU, but when I run the configuration utility and look at the General System Information, it still says that I have a pentium 100 and 1 mb RAM.
After I did the trick with switch 3 it was still the same.