Netserver LH Pro and Nav CD

[Mike_245]

Thanks. My Navigator CD hangs when I launch into the Disk Array Utility. Does anybody know of an alternate way to get at the RAID config? CMD-M at startup also seems to hang...

[Theo Hill_1]

try removing the HDD connected to it one at a time, see if that helps you get into CTRL-M.

[Mike_245]

Thanks - I removed the first of the six drives and rebooted with a CTRL-M but it did the same thing. Comes up with...

Host Adapter-0 Firmware ver..
Battery Module is present..
1 Logical drive found on ...
1 Logical drive handled by..

Then it halts with a blinking cursor... Any ideas?

[Theo Hill_1]

That is odd, try disconnecting the cable to the backplanes and see if the same thing happens. If it does, try performing a clear cmos on the system, and then try going back in.