Netserver LS will not boot

[Gary C]

I have an older Netserver LS/2 that will not boot. I get no errors, it just stops after checking the HP disk array. It won't boot from floppy or CD-ROM. Any suggestions?

Thanks.

[Joe Colucci_1]

Gary,

1. Check the boot order in the system setup (F2 at startup). The default is usually floppy, CD, then hard drive.

2. Check the NetRaid config (ctrl-M during startup).

Can you boot from a floppy or CD?

--Joe

[Theo Hill_1]

I would try and clear the cmos, which will require you to boot onto the ECU utility and reconfigure your deviced. Here is a link to show you where the clear cmos switch is located:

http://netserver.hp.com/support/parts_service/system_board/sys_board_tpl.asp?pid=LS