NetServer LX Pro

[Mark Patchett]

I'm reworking a donated LX Pro for a small school in my area and I've installed NetWare on the server but I have two issues that are annoying (although not causing any noticeable problems).

1. The ECU always says that it has added one board and removed another. I've saved the config countless times, but not sure where to go from here. I don't remember the version number of the BIOS or ECU so I'm not sure if either are current.

2. The server continually sets the MPS setting from 1.4 to 1.1. As NetWare loads, it uses the MPS14.PSM but it does report that it is using the 1.1 spec. I've also set this setting countless times in the ECU, but it keeps going back.

Any info would be appreciated.

[Theo Hill_1]

You should start with making sure your BIOS and ECU are up to date:

http://h20004.www2.hp.com/keeper_rnotes/bsdmatrix/matrix50460.html