Problems with LH4/NetRaid 3si

[Miguel Salas]

After a power loss I can't see raid 5.
I get the following error:
stop: c0000135 unable to locate DLL
The dynamic link library winsrv.dll could not be found in the specified path.
After the error, the server reboot.
I installed NT in a IDE drive and I can't see the d: drive
Any help?

[Marino Meloni_1]

hi,
Upon some configuration of the netraid, the data in the netraid cache could be protected or not, then during a power failure you could have lost of data.
Then in this case, you have to repair your OS.
If this is not the case, then you could get a corrupted raid, in order to solve this, you can run a consistency chek from Express tool at boot time or with netraid assistant if you start with your CD-Rom Navigator.
Be sure that no disk has been forced on-line after a fail, (a rebuild is the right sequence)
bye
marino

[Terri Harris]

You report that you have an IDE drive installed in this LH4.
Where is the OS installed? Is the OS installed on a RAID 1? Are you using the IDE drive in a RAID array?
Since IDE drives were not tested in the Netserver LH4, this may cause unpredictable results. I would recommend using only the tested & supported HP SCSI drives.