cannot boot my system from CDROM

[benseghir_1]

hello,
i cannot boot my system from CDROM,in disk i have bad lif and then i want to boot from CDROM , i do search boot device, then i got

P0 0/0/3/0.0 media.0 random access media 0
P1 0/1/1/0.1 intscsia.1 random access media 0
P2 0/1/1/0.0 intscsia.0 random access media 0
P3 0/4/2/0.0 random access media 7
P4 0/5/2/0.0 random access media 7

i cannot boot from any of this Pi

when i choose P4 i got
Booting to initialise with ENTRY_INIT status=-7
when i choose P0 P1 P2 P4 , i got
not a boot path

when i do autoboot, i got bad lif

please can i have any help

[Devender Khatana · Accepted solution]

Hi,

It can be a drive or CD issue. The drive as are not used frequently can have dust accumulated on the lens & CD media can also have the problems ?
Try cleaning drive lens first.

What if you boot from the disk & go to LVM maintenance mode from ISL using hpux -lm.

HTH,
Devender

[Mahesh Kumar Malik]

Hi

At IPL search for bootable media by sea ipl and then see if CD drive is listed. Else media or drive can be bad.

Regards
Mahesh

[benseghir_1]

thanks for your help;

the probleme was in my drive of CDROM

thanks

[Devender Khatana]

Hi,

This forum follows a point based system. The points which you assign to the replies to your questions according to the relevance of the answers helps others to search for solutions without requiring to post new threads.

Your profile shows you never assigned points. Please take some time and assign point to all the replies to your questions according to there relevance. This will be your contribution in improving these forums.

Your questions are listed here.
http://forums2.itrc.hp.com/service/forums/pageList.do?userId=CA1247462&listType=question&forumId=1

Regards,
Devender

[Deepak.R]

Hi,

give sea ipl at BCH main menu and wait for it to search bootable medias , then try the No. corresponing to the CD-ROM drive

It could be a CD problem as well.

thanks

[prashanth_14]

We had similar issue and was fixed by properly inserting/securing ide/scsi connector behind cdrom drive. Could you have a look.

[Hanwant Verma_1]

It is a cdrom drive issue, you have to replace your cdrom drive. I had the same problem and i tried all the neccessary commands to check whether cdrom is working or not. Just replace your drive and it will work.