change network

[Porphirio]

how i do for restart networking service after change netconf file?

[Robert-Jan Goossens]

Hi,

From the console.

# /sbin/init.d/net stop

# /sbin/init.d/net start

or reboot your system.

Regards,
Robert-Jan

[Asif Sharif]

After making change in "netconf" you can simple restart network services by following these commands.

/sbin/init.d/net stop
/sbin/init.d/net start

Regards,
Asif Sharif

[Mobeen_1]

Make the required changes and perform following commands from the console :)

/sbin/init.d/net stop
/sbin/init.d/net start

regards
Mobeen

[Ralph Grothe]

Don't forget that if you logged in via ssh, telnet etc. through a NIC affected by netconf that you most likely won't be able to execute the "/sbin/init.d/net start" after the stop anymore ;-)
Either set up an at job to run both commands or do it from (LAN) console.
If you are daring most times a single
/sbin/init.d/net start
after changes of netconf also would suffice, however.

[Shoghi_1]

If over the network (telnet, ssh) do it in just one command sending it to the background, becouse comunication can be disrrupted if the NIC afected is the one you are connected.

/sbin/init.d/net stop;/sbin/init.d/net start&