cmcheckconf/cmruncl error...

[phil raja]

I am installaing 10gr2 RAC with HP Serviceguard, using SLVM as storage.

The installation is carried out on single node.
When i isssue a command

cmruncl -v -n lcnsew3

I ge the followign error message
"Unable to get a handle for the local cluster: No such file or directory"

Similarly i get the message on issuing the command;
cmcheckconf -v -C rac.asc

lcsnew3 lan2 can communicate with lcsnew3 lan3 over subnet 10.10.10.0
on the IP level, but not on the DLPI level.
There is possibly a network component between the two interfaces
that does not allow any data link level traffic through, which violates
a Serviceguard requirement.
lcsnew3 lan3 can communicate with lcsnew3 lan2 over subnet 10.10.10.0
on the IP level, but not on the DLPI level.
There is possibly a network component between the two interfaces
that does not allow any data link level traffic through, which violates
a Serviceguard requirement.
Non-uniform connections detected:
lcsnew3 lan3 is assigned to bridged net 1
but it should be assigned to bridged net 2
to which lcsnew3 lan2 belongs.
Failed to evaluate network

Please help...
Regards,

[melvyn burnard]

looks like you ave a problem with your networking configuration or connectivity.
Revioew and correct this

[rariasn]

Hi phil,

Non-uniform connections detected:
lcsnew3 lan3 is assigned to bridged net 1
but it should be assigned to bridged net 2
to which lcsnew3 lan2 belongs.
Failed to evaluate network

ran