HPE Community
Operating System - HP-UX
1856476 Members
2453 Online
104113 Solutions
New Discussion

CP 2450

 
Richard Boutot
Occasional Advisor

‎03-22-2008 10:04 PM

‎03-22-2008 10:04 PM

CP 2450

When I'm trying to boot up my unix machine, I get the following code VG 0 : PV 0 is POWER FAILED. Then it won't continue the boot up. I've swapped my harddrives with the same indications. Any suggestions
0 Kudos
Reply
3 REPLIES 3
Jeeshan
Honored Contributor

‎03-22-2008 10:32 PM

‎03-22-2008 10:32 PM

Re: CP 2450

Hi

Check your scsi disk terminator.
a warrior never quits
0 Kudos
Reply
Richard Boutot
Occasional Advisor

‎03-22-2008 10:38 PM

‎03-22-2008 10:38 PM

Re: CP 2450

I checked the SCSI terminators and the were good.
0 Kudos
Reply
Jeeshan
Honored Contributor

‎03-22-2008 10:43 PM

‎03-22-2008 10:43 PM

Re: CP 2450

did you check the MP event log?
a warrior never quits
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.