error at boot

[Tarek]

Hallo all,
when I turn on a ws 9000/D series..at the beginning of boot (after scan for bootable devices) an error compare:
FLT 3000
What is this error??? What can it be???
This ws is under warrantee, so we wanna know what kind of problem is this..

[paul courry · Accepted solution]

This is a processor dependent hardware error

FLT 3x00 FEPROM checksum failure

where x is the processor number

Call HP, get them to replace the board if it is under warranty.

Be advised, this interpretation is from a K-class manual, but I don't think they changed it for the D-class.

[Rita C Workman]

FLT tells you that your have a system fault and the system has halted. The 3000 gives you more info:
3x00 tells you it's FEPROM and the x tells you the processor memory bus slot #. These are processor dependent hardware codes - so this is telling you it's probably got a hardware problem.
Here's a thread...look way down and you'll see a chart that explains these codes:
http://us-support.external.hp.com/cki/bin/doc.pl/sid=f35f77470121d5cde2/screen=ckiDisplayDocument?docId=200000052370043

You need to call HP...
Regards,
/rcw

[Andreas Voss]

Hi,

bad news,

FLT 3000 means: FEPROM checksum failure

This message comes from: Major Code Category 3: Processor Dependent Hardware (PDH) Codes

Think you have to contact HP.

Regards

[Tarek]

Thanks all.
Rita i went to the link, but it talks about K series. I have problem on D series.
Is it the same?? I hope so...
Thanks again

[Rita C Workman]

As Paul mentioned...I believe these codes are applicable to K and D boxes..

..at least when I've seen similar codes, I have used the same chart (I have D and K boxes) and supplied HP with the same info.

/rcw