HPE Community
Operating System - HP-UX
1834657 Members
2853 Online
110069 Solutions
New Discussion

failed setup

 
carl_46
Advisor

‎06-14-2000 11:49 AM

‎06-14-2000 11:49 AM

failed setup

when I try to boot up from my 11.0 core cd it first loads isl then trys to run the INSTALL then returns with the "exec failed" message. Earlier yesterday I was able to boot successfully off the same cd, same workstatoin and same cdrom. Any ideas?
0 Kudos
Reply
2 REPLIES 2
Marcel Eken_2
Frequent Advisor

‎06-14-2000 10:01 PM

‎06-14-2000 10:01 PM

Re: failed setup

Hi,

It could be possible that your cdrom player is defect.

Try to boot from an external cdrom player.

Marcel,
0 Kudos
Reply
Patrick Wessel
Honored Contributor

‎06-14-2000 10:56 PM

‎06-14-2000 10:56 PM

Re: failed setup

did you interrupt the boot process to interact with ISL?
You better don't do that with an install media. Just let it boot...
There is no good troubleshooting with bad data
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.