HPE Community
Operating System - HP-UX
1832651 Members
2730 Online
110043 Solutions
New Discussion

Host ID

 
Jupiracy da SIlva Costa
Advisor

‎06-04-2004 06:47 AM

‎06-04-2004 06:47 AM

Host ID

Can't display host id with commando uname -i
jupysilva
0 Kudos
Reply
3 REPLIES 3
Sridhar Bhaskarla
Honored Contributor

‎06-04-2004 06:49 AM

‎06-04-2004 06:49 AM

Re: Host ID

Hi,

WHat error do you get?.

You can also get this from getconf.

#getconf MACHINE_IDENT

-Sri
You may be disappointed if you fail, but you are doomed if you don't try
0 Kudos
Reply
Chris Watkins_1
Respected Contributor

‎06-04-2004 06:53 AM

‎06-04-2004 06:53 AM

Re: Host ID

Try this command instead:

# getconf MACHINE_IDENT
Not without 2 backups and an Ignite image!
0 Kudos
Reply
Bill Hassell
Honored Contributor

‎06-04-2004 01:52 PM

‎06-04-2004 01:52 PM

Re: Host ID

The machine identification is set at the factory or in the field for a replacement CPU board. If the value reported by uname -i is very small (3 digits or less) or negative, then the CPU board needs to be updated. Only HP is authorized to make this change.


Bill Hassell, sysadmin
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.