HPE Community
Operating System - HP-UX
1833776 Members
2318 Online
110063 Solutions
New Discussion

Re: I am adding a new NIS Slave and recieving errors.

 
carlos mendoza_3
Occasional Contributor

‎10-04-2005 12:17 PM

‎10-04-2005 12:17 PM

I am adding a new NIS Slave and recieving errors.

I issues a ypinit -s master_server DOM=TIMEHP from the slave to be set up and recieve the following: ypxfr: bind_to_server clntudp_create error: RPC Rpcbind failure -RPC: Timed out. For each map it is tring to transfer, Any ideas?
0 Kudos
Reply
3 REPLIES 3
Adisuria Wangsadinata_1
Honored Contributor

‎10-04-2005 02:50 PM

‎10-04-2005 02:50 PM

Re: I am adding a new NIS Slave and recieving errors.

Hi,

Check the url below :

http://www2.itrc.hp.com/service/iv/docDisplay.do?docId=prodITRC/DE_SW_UX_nis_EN_01_E/Configuration/nis_slave.htm

Hope this information can help you.

Cheers,
AW
now working, next not working ... that's unix
0 Kudos
Reply
Arunvijai_4
Honored Contributor

‎10-04-2005 03:15 PM

‎10-04-2005 03:15 PM

Re: I am adding a new NIS Slave and recieving errors.

Have you applied PHNE_33315 ?
http://www2.itrc.hp.com/service/cki/patchDocDisplay.do?patchId=PHNE_33315

-Arun
"A ship in the harbor is safe, but that is not what ships are built for"
0 Kudos
Reply
carlos mendoza_3
Occasional Contributor

‎10-05-2005 02:40 AM

‎10-05-2005 02:40 AM

Re: I am adding a new NIS Slave and recieving errors.

Thank you for the info it was a lot of help in fixing the issue.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.