HPE Community
Operating System - HP-UX
1834045 Members
2512 Online
110063 Solutions
New Discussion

Re: ignite backup problem

 
Shah Gaurang B.
Frequent Advisor

‎03-21-2006 08:50 PM

‎03-21-2006 08:50 PM

ignite backup problem

Hi Friends,

I have 2 itanium servers . One server is having backup drive . Now i have to take ignite backup of unother server of vg00 without disconnecting backup drive from other server because to connect it i also need controller of unother server . Both servers are in same network.so is there any special command through which i can take ignite backup. Pl. guide me to solve this problem

0 Kudos
Reply
3 REPLIES 3
RAC_1
Honored Contributor

‎03-21-2006 08:52 PM

‎03-21-2006 08:52 PM

Re: ignite backup problem

man make_net_recovery
There is no substitute to HARDWORK
0 Kudos
Reply
Raj D.
Honored Contributor

‎03-21-2006 09:02 PM

‎03-21-2006 09:02 PM

Re: ignite backup problem

Hi Shah ,

You can use make_net_recovery to take backup of the other server , where tape drive is not present.

To setup an ingite server for network backup check this command:

/opt/ignite/bin/ignite.

hth,
Raj.


" If u think u can , If u think u cannot , - You are always Right . "
0 Kudos
Reply
Raj D.
Honored Contributor

‎03-21-2006 09:04 PM

‎03-21-2006 09:04 PM

Re: ignite backup problem

Shah(Again),

Also you can check this good document to setup an Ignite server , to take the Ignite backup over the network :


http://docs.hp.com/en/B2355-90153/ch04s03.html



Cheers,
Raj.
" If u think u can , If u think u cannot , - You are always Right . "
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.