ignite installation issue

[amitxxx]

I am trying to reignite my current bl860c server and i am getting the following error while booting from ignite cd any ideas how to fix it?

Swap device table: (start & size given in 512-byte blocks)
entry 0 - auto-configured on root device; ignored - no room
WARNING: no swap device configured, so dump cannot be defaulted to primary swap.
WARNING: No dump devices are configured. Dump is disabled.
Starting the STREAMS daemons-phase 1
sh: pre_init_rc: not found
Create STCP device files
Starting the STREAMS daemons-phase 2
$Revision: vmunix: B11.23_LR FLAVOR=perf Fri Aug 29 22:35:38 PDT 2003 $
Memory Information:
physical page size = 4096 bytes, logical page size = 4096 bytes
Physical: 8357608 Kbytes, lockable: 6073360 Kbytes, available: 7106508 Kbytes

* Preparing to execute init...
======= 06/12/09 01:05:50 EDT HP-UX Installation Initialization. (Fri Jun 12
01:05:50 EDT 2009)
@(#)Ignite-UX Revision C.7.1.93
@(#)ignite/launch (opt) $Revision: 10.590.1.2 $ $Date: 2006/12/18
20:51:11 $
* Configuring RAM filesystems...
* SAS (Serial Attached SCSI) disk devices (LUNs) found = 1.
* No SAS disk/LUN swaps required, already in physical location order.
* Current SAS disk/LUN status:
* 0/2/1/0.0.0.0.0 0x060ed597d4d566dd.0x0
SAS:VOL060ED597D4D566DD:ENC01:BAYS01,02 "HP IR Volume "
* Scanning system for IO devices...
aCC runtime: pure virtual function called for class "".
WARNING: send_smapi_command: smapi_send_and_wait failed, got: CONTINUE
ERROR: IO action QUERY_PROCESSOR failed: got
WARNING: Could not find Q_BOOT device. Cannot determine what the boot device
was.
ERROR: Could not get io-device data (ioscan)
WARNING: send_smapi_command: smapi_send_and_wait failed, got: CONFIG_SAVE
ERROR: Could not write disk information file
NOTE: System rebooting...
Shutdown at 01:06 (in 0 minutes)
System shutdown time has arrived

[sujit kumar singh]

Hi



Please have alook at the following thread, this shall be helpful.

1) check system firmware, upgrade if old.
2) You are telling IGnite Media, what is that ? use HP-UX Core OS and Install Media
3) What is the Drive That you are using,are yiu using a USB Drive CDROM?
4) Try assigning the Laptops CDROM , connecting to the server as Virtual Media From The Blade Enclosure ILO.

regards
sujit

[Steven E. Protter]

Shalom,

It does appear that the source of the Ignite backup is not this machine.

Ignite has several functions for replicating machines. The least hardware dependent is Golden Image.

Taking a make_net_recovery from say ans rx3600 and laying it down on this system is likely to cause this problem due to hardware differences.

So please add a little information:

OS version
Ignite version
Source of the backup

SEP

[amitxxx]

Hi this is blabe bl860 server, I have ignited the server a week back and everthing went fine. Today I am again tryin gto reignote it but it is throwing me the above error

I am connecting the server through vertual media and contacting it with ignite server to push the image..