HPE Community
Operating System - HP-UX
1839699 Members
3082 Online
110153 Solutions
New Discussion

k570 boot up problem

 
SOLVED
Go to solution
Otto Folprecht
Advisor

‎12-21-2004 04:32 AM

‎12-21-2004 04:32 AM

k570 boot up problem

Have a problem with booting up our old k570. After turning on the power the boot up seqence on the front panel in the seqence stops at INIT C440 PRI CNSL 01. What next or do I have faulty hardware? THX Otto
0 Kudos
Reply
3 REPLIES 3
Steven E. Protter
Exalted Contributor

‎12-21-2004 04:39 AM

‎12-21-2004 04:39 AM

Solution

Re: k570 boot up problem

This thread has the exact error message you are receiving:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=224489

Though the answer assigned no points there is a reasonable chance that a solution for you is in the thread. Just for grins, reset your console and any attached printers.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Reply
A. Clay Stephenson
Acclaimed Contributor

‎12-21-2004 04:40 AM

‎12-21-2004 04:40 AM

Re: k570 boot up problem

Do you have a console connected? Just after this message is displayed you should see a firmware menu displayed on the console.
If it ain't broke, I can fix that.
0 Kudos
Reply
Kevin Nikiforuk
Valued Contributor

‎12-21-2004 05:05 AM

‎12-21-2004 05:05 AM

Re: k570 boot up problem

When you see error C440 mean the system is
looking for console. Make sure you have an HP
terminal or a laptop hookup as console.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.