kernel para change (mxssize,mxssize_64bit) INIT: Command is respawning

[Akif_1]

Hi,

As i mentioned above.

> Iam unable to login via secure mode by disturbing in 10sec "NO message" of such kind appear during booting. May be due to kernel failed.

>Serial connectivity not establishing a blank screen appear already changed cables, But result is same as above.

> If i could login/telnet/serial then i can play with the file.

Rgd's.

[Dennis Handly]

>I am unable to login via secure mode

Have you read the links I provided and have disconnected the disk drives, so you can disable secure boot?

[Akif_1]

Following steps is to stop boot up:
1. Remove/disable the hard disk drive.
2. Reboot system.
3. The system will prompt that it cannot find a boot device.
4. You may Press the Esc key.
5. In admin mode, you can disable "secure mode".
6.CO - SEC OFF.

>Now iam able to disturb in 10 SEC

And when i try to boot with /stand/vmunix.prev again kernel failed and above old INIT messages replying.

I have two SCSI disk how can i use alternate disk to boot the system in normal behavior and change the kernel parameter for normal behavior.

I highly appreciate Mr.Dennis recommendations for a genuine support among others.

[Akif_1]

When i try to boot with /stand/vmunix.prev again kernel failed and above old INIT messages appear.

Alternate SCSI problem solved with SEA(Search command).

After booting ISL from CDROM(CORE OS & RECOVERY MEDIA) unable to boot 800/700SUPPORT.
Error:Unable to find 800/700SUPPORT FILE.

Needed valuable input ............