MC Serviceguard

[Leoanrdo Bowens]

I created a 2 node cluster which works very well. At this point I only have one lan port in use. All scenarios of the failover works fine. i.e reboots, manual switching of packages, etc. The problem is when I pull the lan card, the system hangs but the package does not failover to the secondary node. I have tested this on both nodes and get the same results. When I plug the cable back in the packages are still up and running. The package control and conf files appear to be ok. Any advice?

[Slawomir Gora]

Hi,

1. do you use cluster disk lock ?
2. do you have only one LAN (no separate Heartbeat) ?

[Geoff Wild]

What are you using for a cluster lock and heartbeat?

With a single LAN card, you can use the serial port for heartbeat...

Any messages in syslog after you pull the lan cable?


Rgds...Geoff

[melvyn burnard]

run cmscancl and supply the contents of the /tmp/scancl.out file
Also which version of SG, and what SG patch is installed? Run:
what /usr/lbin/cmcld |grep PHSS

[Leoanrdo Bowens]

Yes, I have a cluster lock disk functional. I do have a heartbeat ip also configured on a lan port

[Slawomir Gora]

Hi,

can you attach you package config file.
Did you set SUBNET param in config file for monitoring.

[Geoff Wild]

Okay, are the packages dependent on the lan card? IE - do you have a "relocatable" ip address assigned to the packages?

Rgds...Geoff

[Leoanrdo Bowens]

Thanks for all the help. I discovered I did not have a SUBNET in the pkg.conf file. All should be ok now.