package does not happen to the other node

[Carlos F. Baladrón]

When it fails a node the package does not happen to the other node

Error en syslog:
Package cannot run on this node because awitching has been disable for this node

HPUX 11.11
ServiceGuard 11.14

[melvyn burnard]

so do a cmviewcl -v and look at the switching parameters for the package. Make sure you look at both the GLOBAL and also LOCAL switch settings.
enable htem if needed by using hte cmmodpkg command.
and see if hte package will run, if it does not, look at the associated package log on hte node you tried to run it on.

[Carlos F. Baladrón]

Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled serv1 cur
Alternate up disabled serv2

As it is qualified permanently ??

[Duncan Edmonstone]

Hi,


cmmodpkg -e -n serv2

should allow failover to serv2

HTH

Duncan