HPE Community
Operating System - HP-UX
1833137 Members
3333 Online
110051 Solutions
New Discussion

PADEM configuration

 
Jaimin Parikh
Frequent Advisor

‎08-07-2001 07:59 PM

‎08-07-2001 07:59 PM

PADEM configuration

Dear Friends,

Can anybody help me in configuring Padem on X25 network? I have PSI (HP-PB) interface card and whenever I am trying to enable it, it gives me a message that "without a network connection card cannot be enabled".

I am using V35 modem as DCE and my server and omy telecom switch are DTE. I am getting carrier between both the modems but still I am not able to enable the card.

Please help me, if anybody is using similar configruation.

Thanks
Jaimin Parikh
JAIMIN PARIKH : Share your knowledge and help those who need your help!!
0 Kudos
Reply
1 REPLY 1
Ravi_8
Honored Contributor

‎08-07-2001 11:28 PM

‎08-07-2001 11:28 PM

Re: PADEM configuration

Hi,
are you able to dial out without the padem?
if you are able to dial out check whether the padem card does support the modem which you are using.

later
ravi
never give up
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.