Partition Manager

[Jeffrey F. Goldsmith]

I opened SAM this morning and tried to get into Partition Manager and received the following error:

com.hp.parmgr.model.DiscoveryError: Error while getting an instance: URL = http://localhost:5988 namespace = root/cimv2/npar name = HP_NParComplex key(s) = [sint32:ProfileID=0].CIM_ERR_NOT_SUPPORTED(CIM_ERR_NOT_SUPPORTED: The requested operation is not supported: "@31:The system is not using a compatible version of IPMI. The nPartition Provider supports IPMI 1.5.[The system () is using IPMI 1.0]")

Can I find IPMI 1.5 at this site? What is IPMI anyway?

Thanks.

[Geoff Wild]

Only software I found related to this was:

http://h20293.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=SYSFAULTMGMT

Man page:

"The /dev/ipmi driver allows user processes to send IPMI messages to the BMC (Baseboard Management Controller) System Message Interface."

http://docs.hp.com/en/B2355-60105/ipmi.7.html

Rgds...Geoff

[Sameer_Nirmal]

Hi,

It seems that you are using partition manager version 2.0.
Check the version of System Fault Management (SysFaultMgmt) on the systm using
# swlist -a revision SysFaultMgmt

IPMI is a part of System Fault Management which is used by WBEM and its providers.

The details of IPMI could be found at
http://docs.hp.com/en/5991-1247/ch01s06.html

http://h20293.www2.hp.com/portal/swdepot/displayProductsList.do?category=ISS

http://h20293.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=SYSFAULTMGMT

You may need to install latest version of
SysFaultMgmt.

[Jeffrey F. Goldsmith]

root: / ==> swlist -a revision SysFaultMgmt
# Initializing...
# Contacting target "gravina"...
ERROR: Software "SysFaultMgmt" was not found on host "gravina:/".

I checked the website for System Fault Management and found that it isn't supported on my rp3440-4 server.

[Geoff Wild]

The RP3440 isn't a partitionable supported server.

Lowest model is the RP7420 (or older RP7410).

Rgds...Geoff

[Sameer_Nirmal]

Hi,

Aah!! rp3440 server!!
It is not partitionable (npar capable) server. I know even on non-partitionable server and is "vpar" supported, partition manager s/w is a requirement of "vpar" software. Saying that, "vpar" software uses partition manager for its operation.

As far as the IPMI is concerned for this server , MP/iLO does provide IPMI support. You can check the MP/iLO and IPMI version using MP Interface.
MP > CM > SYSREV

You may need to upgrade the MP/iLO firmware.
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=406769&prodTypeId=15351&prodSeriesId=443375&swLang=13&taskId=135&swEnvOID=54