paths problems

[Juan Pablo Wagner_1]

Hello

i have a RP2620. I install my equipment and run a make_tape_recovery. To test my back up I install in other hard disk that i have. Every thing its fine, my restore works perfectly, but when i return the original disk to the equipment it sends a messages that that its no posible boot from this path.
Anaybody knows what happen?

Thanks

[Adisuria Wangsadinata_1]

Hola Juan Pablo Wagner Naveda,

I believe rp2620 is HP Itanium server.

For HP Itanium server, there's a different procedure to restore the Ignite/UX backup tape. Just follow the steps on document below about 'How to boot/recover from tape on Itanium' (docID : IA64KBRC00015995) :

http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000081616674

Hope this information can help you.

Cheers,
AW

[Juan Pablo Wagner_1]

Thanks for your help. I repeat the process and works fine.

[Dennis Handly]

>AW: I believe rp2620 is HP Itanium server.

No, models with rp#### are PA-RISC and rx#### are Integrity.