HPE Community
Operating System - HP-UX
1831645 Members
2234 Online
110029 Solutions
New Discussion

SAM error when trying to access user data

 
Lee Abell
Frequent Advisor

‎09-03-2003 12:19 PM

‎09-03-2003 12:19 PM

SAM error when trying to access user data

I just removed NIS from the system via SAM. Then I trusted the system via sam. I was trying to go in and modify some individual user security policies when I got the attached error message. This is a G70 running 10.20. Thanks!
0 Kudos
Reply
3 REPLIES 3
Sridhar Bhaskarla
Honored Contributor

‎09-03-2003 12:25 PM

‎09-03-2003 12:25 PM

Re: SAM error when trying to access user data

Hi,

Go to /var/sam/log and look at the file samlog to see if there are any errors.

There may be a problem with the tcb database. Run 'pwck -s' and 'grpck' commands to see if the entries are consistent.

-Sri
You may be disappointed if you fail, but you are doomed if you don't try
0 Kudos
Reply
Elena Leontieva
Esteemed Contributor

‎09-03-2003 12:29 PM

‎09-03-2003 12:29 PM

Re: SAM error when trying to access user data

Take a look t this link "Sam core dumps while trying to trust the system" DocId: KBRC00006672:
http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000062908222

Elena.
0 Kudos
Reply
Helen French
Honored Contributor

‎09-03-2003 12:38 PM

‎09-03-2003 12:38 PM

Re: SAM error when trying to access user data

Try doing these:

# swconfig \*

See if it solves the problem

# swconfig latest_sam_patch

see if it solves the problem

OR reinstall/install latest SAM patch.
Life is a promise, fulfill it!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.