HPE Community
Operating System - HP-UX
1834862 Members
2282 Online
110070 Solutions
New Discussion

Re: SCSI Timeout

 
j773303
Super Advisor

‎11-26-2003 08:32 PM

‎11-26-2003 08:32 PM

SCSI Timeout

Is it possible configure the SCSI timeout if I put off the disk then the os would detect disk be removed,and generate such as,

SCSI Timeout or
SCSI power faild or
SCSI reset
Hero
0 Kudos
Reply
2 REPLIES 2
Mark Grant
Honored Contributor

‎11-26-2003 08:55 PM

‎11-26-2003 08:55 PM

Re: SCSI Timeout

The closest thing I can think of, which I don't think provides all that you are asking for, though might be enough, is to use "pvchange -t" to change the i/o timeout value.
Never preceed any demonstration with anything more predictive than "watch this"
0 Kudos
Reply
Fabio Ettore
Honored Contributor

‎11-26-2003 09:16 PM

‎11-26-2003 09:16 PM

Re: SCSI Timeout

Hi,

pvchange -t

default is 120 seconds, you could change it to 180.
Anyway most of the times messages about SCSI resets,timeouts or power failed indicate hw problems.

I hope this helps you.

Best regards,
Ettore
WISH? IMPROVEMENT!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.