HPE Community
Operating System - HP-UX
1832557 Members
5720 Online
110043 Solutions
New Discussion

SysInfo for Itanium

 
SOLVED
Go to solution
ap_4
Occasional Contributor

‎05-25-2007 03:46 AM

‎05-25-2007 03:46 AM

SysInfo for Itanium

Hi,

I am using SysInfo on RISC systems and want to know if anyone knows if SysInfo will run on Itanium. If so, does anyone know where its located.

I have a rx6600 11.23

Thanks
Alice
0 Kudos
Reply
3 REPLIES 3
Oviwan
Honored Contributor

‎05-25-2007 03:53 AM

‎05-25-2007 03:53 AM

Re: SysInfo for Itanium

Hey

check "print_manifest" and "machinfo"

Regards
0 Kudos
Reply
spex
Honored Contributor

‎05-25-2007 03:57 AM

‎05-25-2007 03:57 AM

Re: SysInfo for Itanium

Alice,

It doesn't appear to be supported. But why use 'sysinfo' when there's 'stm', 'machinfo, 'model, 'uname -a', and 'print_manifest' (with Ignite-UX)?

PCS
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎05-25-2007 03:59 AM

‎05-25-2007 03:59 AM

Solution

Re: SysInfo for Itanium

see this thread and consider to try cfg2html too:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=822619

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.