trimlog,syscheck and samba

[Mangesh Khatav_1]

sir,

i need to know if their is any command to check the system like in tru64 we use sys_check
and also i want to know that is their any command called trimlog or trim in hp-ux .i dont find these

command in my hp w/s.but i heard it from somewhere that it exists.
i also would like to know if i can install samba on hpux 11i.


pls revert back
thanks in advance

regards
mangesh

[Eric Antunes]

Hi mangesh,

About trimlog, you can trim system logs in SAM (Routine Tasks->System Logs->...)

About sys_check, I don't know any command but there is sar (to check activity).

Best Regards,

Eric

[Mangesh Khatav_1]

is their any command line for trimlog or any script.i want a command which will check the full system and give me a file as i can check in tru64 unix.also i need some information about samba

[Eric Antunes]

Hi,

Trim a log file on SAM (run SAM as root) and, after that, view SAM Log to see what command(s) is(are) executed. SAM is basically an user interface...

Best Regards,

Eric

[Ranjith_5 · Accepted solution]

Hi Mangesh,

1.) sys_check I believe it is used to find the system config info. IN hp-ux u can use the following to find the system info.

/opt/ignite/bin/print_manifest

A print_manifest output is attached with. Pls see.

2.)There is no command "trimlog" in hp-ux.

3.) You can install samba on hpux 11i. Find it at http://www.software.hp.com/portal/swdepot/searchProducts.do

Regards,
Syam

[Ranjith_5]

Dear Mangesh

if ur queries are cleared pls close this thread.

Thanking you,
Syam

[Mangesh Khatav_1]

I got the solution as the command print_manifest works as sys_check in Tru64.and i got some free softwares from the link given .thanks