X25 connection problem

[Paul Thomson_2]

Hi

I have recently migrated from an L class server running 11.00 to a new server (rp3440) running 11.11.

On the new server, the following software is installed.

J2793B B.11.11.01 High Performance X.25 Link software for HP 9000

I can also see the card in ioscan
psi 0 0/2/1/0 j3525 CLAIMED INTERFACE PCI Network (1133b921)

However, when I start x25 on the new system the following is displayed

[x25init] Device /dev/x25_0p1 is not configured in kernel
CAUSE : sam configuration failed.
ACTION : Check sam configuration.
EXIT CODE: 1
[x25init] Device /dev/nli2zcom is not configured in kernel
CAUSE : sam configuration failed.
ACTION : Check sam configuration.
EXIT CODE: 1

Can you advise please what I need to turn on in SAM / configure etc ?

I have also tried to follow the X25 configuration document and the following is shown
x25stat -d /dev/x25_0p1 | more

IXE:

0 connections
0 datagrams in
0 datagrams out
0 NSDUs in
0 NSDUs out

SUBNETWORK STATISTICS FOR X25
-----------------------------

Subnetwork : 0p1
State : Unknown

-------------------------------------
Packet type TX RX
-------------------------------------

Call 0 0
Call accept 0 0
Restart 0 0
Restart confirm 0 0
RNR 0 0
RR 0 0
Resets 0 0
Reset confirms 0 0
Diagnostic 0 0
Interrupts 0 0
Registration 0 0
Reg confirm 0 0
Packets(total) 0 0
Bytes(total) 0 0
Invalid device prefix: No such file or directory


I have also tried to use eisa_config but this is also not configured !

eisa_config

HP-UX E/ISA CONFIGURATION UTILITY
The eisa (/dev/eeprom) is not in the kernel.
You must add the eisa driver to your kernel. Refer to the
"E/ISA Configuration Documentation".

[Paul Thomson_2]

Oh dear, it would seem after much digging around I didn't need to worry, the engineer that installed this kit did not attach the cable !