FC60 Display Under SAM

[Joe Redman]

When I display my FC60 w/6 SC10's fully configured under SAM (All Disks Status)the controller:device numbers do not match up to actual controller:device number as far as location within each SC10 (i.e. under SAM device 6:10 shows up in 3rd slot from left in bottom SC10 whereas actually located at 6th slot from left in bottom SC10).

Does anyone have any ideas why this is so? If I use the diagram in the HP SureStore E Disk Array FC60 (pg 106) this is correct diagram.

Thanks in advance.
Joe

[Joe Redman]

I found out that SAM does not offer a true representation of what a configured FC60 looks like. It is used for reference only. True depiction can be found in the FC60 manual.