HPE Community
Operating System - Linux
1832924 Members
2817 Online
110048 Solutions
New Discussion

how to set ntp in broadcasting mode

 
Rupal
Occasional Contributor

‎01-10-2007 04:51 PM

‎01-10-2007 04:51 PM

how to set ntp in broadcasting mode

I have installed Ntp on my pc and in its config file i had set broadcast command.
Now when i am running ntpq - p on command line it is again showing it as a unicast.
0 Kudos
Reply
1 REPLY 1
Al Licause
Trusted Contributor

‎01-11-2007 05:57 AM

‎01-11-2007 05:57 AM

Re: how to set ntp in broadcasting mode

Please post the commands from your ntp.conf file. You may be missing something like a key setting.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.