HP SmartArray linux config of boot mirror with hpacucli

[Kevin_31]

Hello gurus, I have hpacucli-7.17-1.linux.rpm
installed and I have linux boot/root/swap installed on the first disk (1:0) and I have another disk exactly the same on (1:1) which is unused. I want to mirror 1:0 to 1:1.

Can you help?

cheers,
Kevin
------------------------------------
[root@mase bld]# hpacucli controller slot=0 physicaldrive 1:1 show


Smart Array 6i in Slot 0
physicaldrive 1:1
SCSI Bus: 1
SCSI ID: 1
Status: OK
Drive Type: Data Drive
Interface Type: Parallel SCSI
Size: 72.8 GB
Transfer Mode: Ultra 320 Wide
Transfer Speed: 320 MB/Sec
Rotational Speed: 15000
Firmware Revision: HPB4
serialnumber: A001P4B08AU50446
[root@mase bld]# hpacucli controller slot=0 physicaldrive 1:0 show

Smart Array 6i in Slot 0
physicaldrive 1:0
SCSI Bus: 1
SCSI ID: 0
Status: OK
Drive Type: Data Drive
Interface Type: Parallel SCSI
Size: 72.8 GB
Transfer Mode: Ultra 320 Wide
Transfer Speed: 320 MB/Sec
Rotational Speed: 15000
Firmware Revision: HPB4
serialnumber: A001P4B08A610446

[root@mase bld]#