HPE Community
Operating System - Linux
1849142 Members
5765 Online
104041 Solutions
New Discussion

Re: HP-SNMP-AGENTS trap generation in v2c support?

 
jim_hart
New Member

‎10-02-2015 02:32 AM

‎10-02-2015 02:32 AM

HP-SNMP-AGENTS trap generation in v2c support?

Hi, I have a DL380 G9 running RHEL 6.6. I am running hp-snmp-agents-10.20-2789.26.rhel6.x86_64.rpm. At present the HP-SNMP-AGENTS generate v1 traps for hardware events (such as redundant PSU failure). My trap aggregator only supports v2c -- is there a way to configure the HP-SNMP-AGENTS to support v2c instead of v1? Any advice on how to proceed? Many thanks,
1 person had this problem.
0 Kudos
Reply
1 REPLY 1
mech1
New Member

‎04-25-2016 06:37 AM

‎04-25-2016 06:37 AM

Re: HP-SNMP-AGENTS trap generation in v2c support?

Hello Jim,

I have the same problem than you.

Did you have any solution for that ? Did you find any workaround ?

Thank you in advance for you help.

Br,

 

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.