HPE Community
Operating System - Linux
1829115 Members
12898 Online
109986 Solutions
New Discussion

Re: PXELINUX Help

 
K.C. Chan
Trusted Contributor

‎06-07-2003 06:51 PM

‎06-07-2003 06:51 PM

PXELINUX Help

Hi,
I am using pxelinux to boot my server up via tftp. On the default file I have this line "
append initrd=initrd.img ks=nfs:10.10.10.33:/redhat/kickstart/blade.cfg"
Is there a way to tell it to use eth1 for configuring the network during bootup? Thanks.
Reputation of a thousand years can be determined by the conduct of an hour
0 Kudos
Reply
2 REPLIES 2
david_69
Advisor

‎06-09-2003 05:32 AM

‎06-09-2003 05:32 AM

Re: PXELINUX Help

I think that you need to make this change in the bios.
fall down seven time stand up eight
0 Kudos
Reply
Jerome Henry
Honored Contributor

‎06-09-2003 08:32 AM

‎06-09-2003 08:32 AM

Re: PXELINUX Help

Well, as David says, it uses the first available eth to perform install.
Best would be to use BIOS options... buta what heppens ? Do both NICs link to 10.10.10.33 ? Or only eht1 ? And if so, is your installation going thru ?
J
You can lean only on what resists you...
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.