HPE Community
Operating System - Linux
1826379 Members
4190 Online
109692 Solutions
New Discussion

Re: stat=Sent (Message received and queued)

 
SOLVED
Go to solution
monu_1
Regular Advisor

‎12-10-2006 08:19 PM

‎12-10-2006 08:19 PM

stat=Sent (Message received and queued)

Hello Mastero!!!!

Last five days i am getting following log after sending mail to our client. Log is as following

Dec 10 19:29:04 mail3 sendmail[16851]: kBADwgjP016822: to=, delay=00:00:08, xdelay=00:00:08, mailer=esmtp, pri=49140, relay=scan.telenor.net. [193.212.240.190], dsn=2.0.0, stat=Sent (Message received and queued)

where is the acctual problem?Is it my end problem?

Please suggest me ...!!!!!

Thanks in Advance.

Manoj k Sharma
0 Kudos
Reply
2 REPLIES 2
Ivan Ferreira
Honored Contributor

‎12-11-2006 12:23 AM

‎12-11-2006 12:23 AM

Solution

Re: stat=Sent (Message received and queued)

The message was accepted by can.telenor.net. and this server should be responsable of delivering the mail.

If you have control over can.telenor.net. check the mail log of this server.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
Reply
George Liu_4
Trusted Contributor

‎12-11-2006 02:08 AM

‎12-11-2006 02:08 AM

Re: stat=Sent (Message received and queued)

It is a normal message
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.