HPE Community
Operating System - Microsoft
1827818 Members
1763 Online
109969 Solutions
New Discussion

Re: Problem with p400 controller

 
Colin Page
Occasional Contributor

‎01-14-2010 03:51 AM

‎01-14-2010 03:51 AM

Problem with p400 controller

I have a BL680c which is booting from SAN and running Windows 2008R2. The OS and hardware are fine but the internal p400 array controller will not start and from Windows device manager displays 'error code 10' device cannot start. The server was ok running 32bit Windows 2008 so I know that the hardware is ok. I have updated firmware to 8.60 and the server is running all of the latest drivers so I'm looking for inspiration.
0 Kudos
Reply
1 REPLY 1
Colin Page
Occasional Contributor

‎01-21-2010 02:00 AM

‎01-21-2010 02:00 AM

Re: Problem with p400 controller

HP found the answer, disable the HBAs and update the firmware on the P400 then re-enable the HBAs.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.