HPE Community
Operating System - OpenVMS
1829613 Members
1872 Online
109992 Solutions
New Discussion

Re: BridgeWorks Cannot allocate Locate Request message No valid protocol found

 
Ralph van Middlesworth
New Member

‎08-23-2004 07:13 AM

‎08-23-2004 07:13 AM

BridgeWorks Cannot allocate Locate Request message No valid protocol found

We are getting the message "com.hp.bwx.BwxConnectException: ERROR: Cannot allocate Locate Request message No valid protocol found" when running the tutorial from the `BridgeWorks documnetation. We tried running it on a singel node on the Alpha. VMS version 7.3, Bridgeworks 3.0. The JavaBeans part of the tutorial was used. THe troubleshooting guide does not have anything about this error. What have we done wrong or not set up properly?

Thank you,
Ralph van Middlesworth
0 Kudos
2 REPLIES 2
Ralph van Middlesworth
New Member

‎08-26-2004 07:01 AM

‎08-26-2004 07:01 AM

Re: BridgeWorks Cannot allocate Locate Request message No valid protocol found

This turns out to be an error in specifying the transport. It says that a node name is ok in the tcp/ip specification, but it really wants the full ip address.
0 Kudos
Ralph van Middlesworth
New Member

‎08-26-2004 07:02 AM

‎08-26-2004 07:02 AM

Re: BridgeWorks Cannot allocate Locate Request message No valid protocol found

See last entry
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.