HPE Community
Operating System - OpenVMS
1829026 Members
2233 Online
109986 Solutions
New Discussion

MDMS Query

 
Shaun Lim
Occasional Contributor

‎02-03-2004 02:02 PM

‎02-03-2004 02:02 PM

MDMS Query

Hi,

I did a tape drive replacement on a tapelibrary ESL9198. After replacement, robot arm was not responding when I issue a move or inventory commands in MDMS.
(e.g. MDMS> move vol GQP253 esl9198_juke/nowait/noassist)

However, load and unload commands in MDMS are working fine.
(e.g. MDMS> load vol GQP253 /drive=$2$mga1 /nowait)

Thank you.

Shaun Lim
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.