MetricView

[Mahmoud_1]

Hi to all,
In fact I have three systems clustered each has two NIC's I enabled the Loadbroker & Metric services for loadbalance, all are working Ok, but The problem is when I issued the metricview command to show customer the raiting values; some times I didn't receive any thing.
Best Regards

[Ian McKerracher_1]

Hello Mahmoud,

I would start by stopping and re-starting the metric service as follows:

$ @sys$startup:tcpip$metric_shutdown
$ @sys$startup:tcpip$metric_startup

Now try metricview again. If it still does not work you should enable the diagnostics log file as follows:

$ define/system tcpip$metric_log_level 1

You can assign a value of 2 to this logical and receive more detailed diagnostics.

The new log file will be called SYS$SPECIFIC:[TCPIP$METRIC]TCPIP$METRIC_RUN.LOG

Hope this helps,

Ian

[Mahmoud_1]

Thanks Lan,
In fact I tried this before but it didnt work and the Level 2 tracing I tried it before and there are no unusual statements.
regards

[Ian Miller.]

can you post the log file?