HP Insight Control for vCenter is still initializing.

[Daniel Ryan2]

When using the HP INsight Software plug-in in vSphere Client I receive the message: "HP Insight Control for vCenter is still initializing." I have tried restarting the vSphere client with no success.
It is Vsphere 4.0 Update 2.
Does anyone know how to get the plug-in to work and get rid of this message?v Thanks

[Satish Keshava Murthy]

Hi Daniel,

Restart the Insight Control service where the Insight Control for vCenter is installed and then check again by logging back into the client

[Dzmitryj Jakavuk]

Have the same problem. The solution above unfortunately didn't help

[johnisccp_1]

Did anyone resolve this issue yet? I am encountering the same issue.

Thanks in advance

[JustinT]

Same issue here. vCenter 4.0 Update 2 has been stuck on this message for over 24 hours

I do not have the issue with another vCenter which is running 4.1 Update 1

That said, my 4.0 Update 2 vCenter has a lot of hosts (60) whereas the 4.1 vCenter (which is working) has just 12, so not sure if that is part of the issue?

HP?