- Community Home
- >
- Storage
- >
- Legacy
- >
- Optical Jukeboxes and Drives
- >
- dead 9100 after flashing
Categories
Company
Local Language
Forums
Discussions
Knowledge Base
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Knowledge Base
Forums
Discussions
- Cloud Mentoring and Education
- Software - General
- HPE OneView
- HPE Ezmeral Software platform
- HPE OpsRamp
Knowledge Base
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2002 04:25 AM - last edited on 02-26-2014 08:10 PM by Lisa198503
07-16-2002 04:25 AM - last edited on 02-26-2014 08:10 PM by Lisa198503
dead 9100 after flashing
After flashing above drive to version 10c its a dead drive.
The fashing sequence was ok. But after a restart it was NOT recognized the the sysem bios. No flashing or blinking led's anymore. Even the tray won't open.
Is there a solution for this problem. Like a flash program thats not listen to the IDE port.
P.S. This thread has been moved from Disk to Optical Jukeboxes & Drives. -HP Forum Moderator