HPE Community
Optical Jukeboxes and Drives
1850991 Members
2106 Online
104056 Solutions
New Discussion

Re: install

 
Nick_6
New Member

‎01-01-2001 06:24 PM - last edited on ‎02-18-2014 04:45 AM by

‎01-01-2001 06:24 PM - last edited on ‎02-18-2014 04:45 AM by

install

When I installed my 9100 series HP writer not only did it not work properly but now my
CD-ROM drive doesn't work either.

Both of them give a message error 31 cannot properly load the driver

HELP

 

P.S. This thread has been moved from  Disk to Optical Jukeboxes & Drives. -HP Forum Moderator

0 Kudos
1 REPLY 1
Alexander M. Ermes
Honored Contributor

‎01-01-2001 11:44 PM

‎01-01-2001 11:44 PM

Re: install

Hi there.
Are these devices SCSI or EIDE ?
For SCSI : check the SCSI - id on both devices ( could be the same ).Is the SCSI-bus terminated ?

For EIDE : Check the jumpers for Master / Slave
setup.

Rgds
Alexander M. Ermes
.. and all these memories are going to vanish like tears in the rain! final words from Rutger Hauer in "Blade Runner"
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.