HPE Community
Optical Jukeboxes and Drives
1856426 Members
2793 Online
104112 Solutions
New Discussion

Re: Win 2k problem

 
John Consiglio_1
New Member

‎10-04-2001 10:26 PM - last edited on ‎02-22-2015 06:49 PM by

‎10-04-2001 10:26 PM - last edited on ‎02-22-2015 06:49 PM by

Win 2k problem

Since I have started using Win 2k I have not been able to write a CD properly. I have all the lastest software and firmware updates from HP's site and it seems to start the process fine and then stop about 4% into the burn cycle and I get a read error. I get a read error whether the source is another CD or a data file on the hard drive. Any suggestions?

 

 

P.S. This thread has been moved from General to Optical Jukeboxes & Drives. - Hp Forum moderator

0 Kudos
2 REPLIES 2
John Consiglio_1
New Member

‎10-04-2001 10:28 PM

‎10-04-2001 10:28 PM

Re: Win 2k problem

Sorry, should have included that it is a HP 7200i
0 Kudos
Dries Bertier
Respected Contributor

‎10-06-2001 03:11 AM

‎10-06-2001 03:11 AM

Re: Win 2k problem

Hi,

Check cabling ! How is your drive connected, it should be on the secondary ide channel as slave. I also had the problem with a defective cdrom player on the same ide channel. Also try to unpower the cdrom reader to test.

Dries
<< please try >>
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.