RDP restarting problem.

[M.Raheel Lodhi]

We have DL360G5 RDP Server and Blade 460c server as a client now we need to install the o/s package; please note that EVA4000 is also connected through the same SAN Switch .Other blades in the enclosure are ONLINE with the EVA 4000 .But we haven’t presented any virtual disks to this particular blade server, the problem is “after booting with WIN-PE it gets restarted after finalizing PE and goes into WIN-PE environment again and again”

[Adrian Clint]

Does that mean you are trying to deploy an os/image to the local disks?

If so. Try entering the Array Config Utility on boot up. If its not there then open the lid and look for a blue plastic item or yellow label at the back of the drives and press it down to reseat the array controller it.

[M.Raheel Lodhi]

yes m trying to install windows server 2003 enterprise edition pack to the blade servers through rdp.... i have chked hardware by installing win2k3(ent) through ILO attached cd-rom and its done perfectly right.... but as i have rdp server so need to install the blade server through this.... but after booting up with PXE boot it always goes into WIN-PE envoironment even after completing WIN-PE finalising stage.

[M.Raheel Lodhi]

i have also tried a solution for restarting that is following but with of no use... the problem is same but the cure is not....

http://h18013.www1.hp.com/products/servers/management/rdp/knowledgebase/00000177.html