802.1x configuration - cannot authenticate to Microsoft NPS

[T-squared]

Setting up initial dot1x configuration on HP 5500 HI - Comware vers 5.20.99

Problem is that cannot get user PC to authenticate using EAP to Microsoft NPS.  I do NOT see EAPoL or Radius packets hitting the NPS from the switch.  I can SSH to the switch using radius authentication, so I know the radius config on the switch is working.

Error in switch log: 8021X/6/DOT1X_AUTH_FAILURE:

Port config
 port link-mode bridge
 port access vlan 144
 undo voice vlan mode auto
 broadcast-suppression pps 3000
 undo jumboframe enable
 lldp compliance admin-status cdp txrx
 qos trust dot1p
 undo dot1x handshake
 dot1x mandatory-domain tos.x.x.x.x
 dot1x port-method portbased
 dot1x
 dot1x eapol untag

Port dot1x config

Equipment 802.1X protocol is enabled
 EAP authentication is enabled
 EAD quick deploy is disabled

 Configuration: Transmit Period   30 s,  Handshake Period       15 s
                Quiet Period      60 s,  Quiet Period Timer is disabled
                Supp Timeout      30 s,  Server Timeout        100 s
                Reauth Period   3600 s
                The maximal retransmitting times    2
 EAD quick deploy configuration:
                EAD timeout:   30 m

 The maximum 802.1X user resource number is 2048 per slot
 Total current used 802.1X resource number is 0

 GigabitEthernet1/0/19  is link-up
   802.1X protocol is enabled
   Handshake is disabled
   Handshake secure is disabled
   802.1X unicast-trigger is disabled
   802.1X user-ip freeze is disabled
   Periodic reauthentication is disabled
   The port is an authenticator
   Authentication Mode is Auto
   Port Control Type is Port-based
   802.1X Multicast-trigger is enabled
   Mandatory authentication domain: tosx.x.x.x
   Guest VLAN: NOT configured
   Auth-Fail VLAN: NOT configured
   Critical VLAN: NOT configured
   Critical recovery-action: NOT configured
   Voice VLAN: NOT configured

Global dot1x config

Equipment 802.1X protocol is enabled
 EAP authentication is enabled

I would like someone to verify my switch configuration and let me know if there a problem with it.  Also any troubleshooting steps I can take to help isolate the problem.  Thanks