HPE Community
Server Management - Systems Insight Manager
1830908 Members
1783 Online
110017 Solutions
New Discussion

Re: All Systems Page not displaying hardware issues

 
Clyde1
Occasional Contributor

‎02-10-2006 06:42 PM

‎02-10-2006 06:42 PM

All Systems Page not displaying hardware issues

We keep this page on display at all times to see for any hdwe issues. The problem is we had a server whose harddrive was bad and the HS(Health Status) icon didn't turn red(crital) to indicate a problem, an email alert wasn't sent out as well. We discovered it while looking through the alert logs. We then went to the homepage for the device and it was indicating the failed drive. Can someone tell me how to fix this. We are running cim5, on w2k3.
0 Kudos
Reply
1 REPLY 1
Rob Buxton
Honored Contributor

‎02-12-2006 06:56 AM

‎02-12-2006 06:56 AM

Re: All Systems Page not displaying hardware issues

If you got no alerts then you'd need to check that the SNMP Trap Destination on the Server concerned has been set.
It needs to point to the SIM Server. It should have sent a trap when the Agents detected the error.

I've also noticed issue where the Overall HW Status is not set to degraded when there is a HW Failure.
I've yet to apply SP4.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.